Board Statistics
Totals Averages
Posts: 257
Threads: 119
Members: 1,623
Posts per day: 0.34
Threads per day: 0.16
Members per day: 2.13
Posts per member: 0.16
Threads per member: 0.07
Replies per thread: 1.16
General
Newest Member: webmaker
Members who have posted: 8.38%
Today's top poster: Nobody (0 posts)
Most popular forum: Help (58 posts, 21 threads)

Most Popular…
Most Replied To Threads Most Viewed Threads
Need bed replacement (9 replies)
Horizontal lines (7 replies)
[Guides] Writers needed (7 replies)
Fan Voltage (6 replies)
Tornado heated bed problem (5 replies)
Spool Holder (5 replies)
Software section (5 replies)
Filament feed problem - E-motor stops while printing (4 replies)
Tornado Controller Menu (4 replies)
Stock hot end (4 replies)
Printing problems caused by the Z axis shaft connector (4 replies)
runaway (4 replies)
Extruder seems to clog up (3 replies)
Sticky section (3 replies)
Y-axis shitfing (3 replies)
[Guides] Writers needed (12,157 views)
[Video] Build instructions by ArcadeEd (9,064 views)
Post your FFF profiles (8,590 views)
Fan Voltage (4,846 views)
Z Axis Inversion (4,358 views)
Need bed replacement (3,601 views)
Y-axis shitfing (3,012 views)
Printing problems caused by the Z axis shaft connector (2,834 views)
Software section (2,701 views)
Tevo Tornado Stepper Motors (2,167 views)
Tornado Controller Menu (2,091 views)
Shifting layers (2,059 views)
Stock hot end (2,043 views)
Common problems and solutions (1,983 views)
Looking to get a Tornado baseline for Cura 3 (1,983 views)