Very Very small layer shifts
#1
Hello!

I'm having some issues with my printer. I'm getting lots of small layer shifts as seen in this 120 mm Pilatus PC-7. This has been sliced using Cura 3.4.1 using the standard CR-10 with the following changes:

Wall Line Count: 4
Top Surface Skin Layers: 2
Print Thin Wall checked
Infill Density: 30%
Default Printing Temperature: 205°C
Default Build Plate Temperature: 65°C
Print Speed: 30 mm/s
Travel Speed: 120 mm/s
Print Acceleration: 200 mm/s2
Travel Acceleration 200 mm/s2
Print Jerk: 5 mm/s
Generate Support checked
Build Plate Adhesion Type: Brim

Printed using PLA, 8 diode smoothers on the X, Y and Z axis. Drivers at 1.05 volts

Any ideas about what could it be? Any recommendations or additional information needed?

Regards!


Attached Files Thumbnail(s)
   
If you don't like tinkering, you won't like 3D Printing
  Reply




Users browsing this thread: 1 Guest(s)