First layer warping problem
#1
Anyone that can give a hint of the reason for this first layer problem printing with PLA?


Attached Files Thumbnail(s)
   
  Reply
#2
(12-31-2017, 12:21 PM)ECL Wrote: Anyone that can give a hint of the reason for this first layer problem printing with PLA?

It turned out to be a First Layer Height problem. I followed Slic3r recommendation where it is stated: "It is recommended to raise the first layer height to match the diameter of the nozzle".
The following 1 user says Thank You to ECL for this post:
  • indycar
  Reply




Users browsing this thread: 1 Guest(s)