06-10-2019, 12:48 PM
Hi
I am a beginner and just started my first print. with my Tevo Flash Dual Z TouchBL. The printer stopped extruding after it layed down the Brim and started working for about 1mm of the print. I tried again a few times and then I noticed that it stopped extruding after the extruding wheel went backwards (rather rapidly) for a second. I noticed that in my Cura settings I had filament "Retraction" ticked so when it went over blank area it would retract the filament so there would not be any dribble. I un-ticked / disabled "filament retraction" and it is working fine........ so far! So the Tevo Flash is not compatible with "retraction", is this correct, or is there another setting or issue that is not making it compatible and if so how can I make it compatible?
I am a beginner and just started my first print. with my Tevo Flash Dual Z TouchBL. The printer stopped extruding after it layed down the Brim and started working for about 1mm of the print. I tried again a few times and then I noticed that it stopped extruding after the extruding wheel went backwards (rather rapidly) for a second. I noticed that in my Cura settings I had filament "Retraction" ticked so when it went over blank area it would retract the filament so there would not be any dribble. I un-ticked / disabled "filament retraction" and it is working fine........ so far! So the Tevo Flash is not compatible with "retraction", is this correct, or is there another setting or issue that is not making it compatible and if so how can I make it compatible?