Z not moving for first several layers
#1
Here is my problem, when printing or even moving manually through screen or octoprint, after I home z axis for what should be the first mm or so z doesn't actually move or barely moves. I have made sure motor is plugged in properly, cleaned and re oiled the lead screw, double and triple checked the coupler, I even moved my endstop up a couple cm. And still I home z then try to move it .1mm and .2mm at a time and it will only move .00-.06 until I hit anywhere from .8-1.2mm and then it moves normally and quite accurately.

Please if anybody has any ideas I could use the help.
  Reply




Users browsing this thread: 1 Guest(s)